Roof Anchor Spec Section

The roof anchor s shall prevent workers from reaching and falling into any open hole or off the edge of a working surface.

Roof anchor spec section.

Restraint roof anchor s shall be designed per ansi z359 2 ansi z359 6. Anchor and components tested for the following loads. Roof tie down system of fall restraint and fall arrest for worker safety. Osha 1910 27 and iwca 1 14 1 2001 window washing standard require that a building owner have roof anchor inspections and certifications performed on an annual basis.

Section 05310 metal decking e. Section 05400 cold formed metal framing f. Standing seam anchor point of following types. The panels and concealed anchor clips shall be capable of supporting a 300 pound temporary concentrated load at the panel mid span in the installed condition.

At ats all of our roof anchor inspection services are designed with compliance in mind for the following standards. Our strongtop permanent suspended maintenance products can be used on concrete structural steel timber and locally reinforced wood buildings. Includes railing systems and roof anchor systems activar construction products group j l. Metal roof panel systems shall have no water leakage at a pressure differential of 6 24 psf when tested in accordance with astm e1646.

Section 05100 structural metal framing d. Contractor to coordinate installation of structural deck to meet requirements of roof anchor manufacturer. Section 03300 cast in place concrete b. The roof anchor s shall comply with the requirements for fall arrest roof anchor s as indicated in this document.

Standards with a safety factor of 2. Minimum concrete strength fc 2 000 psi. Section 03400 pre cast concrete c. The load shall be applied over the entire panel width.

The roof anchor s shall comply with thaler design requirements. Industries jl offers several lines of safety railings to prevent falls into rooftop openings including the saf t hatch railing that fits all brands of existing roof hatches with cap flashing field adjustable to fit flashing size. Minimum 4 thickness for mechanical anchor connection.